MASSO
MASSO Documentation
8.33. G99 – Canned Cycle – Retract Back To R Plane
This command is used in combination with canned cycles to retract the Z axis to the R plane value.
Syntax & Parameters
G99
Example program
N10 G99 G73 X10 Y10 Z-8 R2 Q1 F100
In the above program, after finishing the drilling cycle the Z axis will retract to the value defined by the
R word.
v5.18 - 08 Apr,2021
www.masso.com.au Page 231 of 477
To Next Page
Loading...
