MASSO
MASSO Documentation
16.1.4. Linear Tool Changer configuration
INFORMATION: This tool changer logic is only available on MASSO G3 controllers running
software version 4.02 and above.
WARNING: Please exercise great care when setting the tool changer parameters as incorrect
settings may produce strange results and cause damage to your tool changer. If you are at all
unsure about your settings you may find it useful to use feed rate override to slow the machine
down while you are setting it up. Feed override
Introduction
The linear tool changer logic allows multiple types of linear tool changer setups to be easily configured. Each
tool can be positioned independently giving the user option to have tools in single or multiple rows.
Below are some common examples:
v5.18 - 08 Apr,2021
www.masso.com.au Page 411 of 477
To Next Page
Loading...
Need help?
General
