MASSO
MASSO Documentation
8.14. G32 – Threading Cycle
This command is used on Lathe machines for running threading cycle synchronised with the spindle.
INFORMATION: Taper threading is not supported.
Syntax & Parameters
Z Value (required) - specifies the end location of the Z axis for threading. The distance value will be
the current machine units in use.
F Value (required) - this is the thread pitch value. The distance value will be the current machine
units in use.
Example program
N10 G21 N20 G00 Z0 N30 G32 Z-10 F1.5
In the above program the first line sets the machine units to millimetres.
The second line command moved the Z axis to work 0.00 millimetres.
The third line starts the threading cycle to thread to Z -10 millimetres location while threading at 1.5
millimetre pitch.
INFORMATION: Units are defined as either inches or mm depending on your machines setup or
G20 or G21 command in use.
v5.18 - 08 Apr,2021
www.masso.com.au Page 212 of 477
To Next Page
Loading...
