MASSO
MASSO Documentation
9.15. M30 – End The Program And Rewind
This command ends the program and moves back to the first line of the gcode file.
Syntax & Parameters
M30
L Value When added to the M30 command causes the program to be repeated for the specified
number of cycles. L10 will run the Gcode 10 times before rewinding stopping
L0 Value When L0 is added to M30 the Program will rewind and repeat on an infinite loop.
Example program
N10 G00 X0 Y0 N20 G00 X10 N30 M30 N40 G00 Y10
The N10 line will move both X and Y axis to 0.00 position.
In line N20 the X axis will move to X 10 position.
In line N30 the program will stop and the file will rewind back to line N10, pressing cycle start will start
the program from N10 line.
Infinite Loop
N10 G00 X0 Y0 N20 G00 X10 N30 M30 L0
This program executes lines N10 to N30 before rewinding back to N10 and starting again
automatically. It will continue until it is manually stopped.
Repeat 20 times
N10 G00 X0 Y0 N20 G00 X10 N30 M30 L20
This program executes lines N10 to N30 before rewinding back to N10 and starting again until it has
completed 20 cycles at which time it will rewind to N10 and stop.
v5.18 - 08 Apr,2021
www.masso.com.au Page 251 of 477
To Next Page
Loading...
Need help?
General
