MASSO
MASSO Documentation
7.3. Setup MASSO Plasma
Quick Start Guide MASSO-G3 Plasma Configuration
These notes have been created to assist new users to set up key configuration properties in MASSO
Plasma.
This is not a full configuration guide but seeks to provide configuration guidance. Some items need to be
configured in the correct order or things will not work as expected. It will also point out common pitfalls and
hints for first time users. I understand that users are keen to see things moving as quickly as possible but
usually going slowly and carefully is far quicker than rushing ahead. This does not seek to show how to
connect the various hardware that you will connect to MASSO Plasma but will point to various references to
assist.
INFORMATION: MASSO Plasma does not have a THC built in to it. For more information see the
section below on THC installation
Getting Started
To configure MASSO you first need to connect a minimum of Power supply, Monitor, Keyboard and mouse.
Ideally you would also connect your Estop Switch, drives, limit switches, auto touch off, and VFD though you
can connect these as you configure each of these components.
Power
Please note that a 1 amp fuse must be connected in the feed from your Power supply on the MASSO G3.
The accidental short circuiting of the auxiliary power terminals built into MASSO will cause damage to the
main board if the fuse is not installed.
Safe working Practices when wiring MASSO
Load your Software
Loading software to MASSO G3
Please follow the instructions on this page to get your Software loaded.
v5.18 - 08 Apr,2021
www.masso.com.au Page 164 of 477
To Next Page
Loading...
Need help?
General
