MASSO
MASSO Documentation
8.19. G80 – Cancel Modal Motion
This command is used to cancel Canned Cycles such as G73, G81, G82 & G83.
Syntax & Parameters
G80
Example program
N10 G99 G73 X10 Y10 Z-8 R2 Q1 F100 N20 X20 N30 G80
The first line moves the X & Y axis to 10mm position with retract plane set to 2mm, drilling to Z -8mm,
peck of 1mm at 100 mm/minute feedrate and starts drilling.
The second line moves X axis to 20mm position and drill a hole as per the same values.
The third line cancels the G73 canned cycle.
INFORMATION: Units are defined as either inches or mm depending on your machines setup or if
G20 or G21 command in use.
INFORMATION: After using G80 the current mode is cancelled and replaced with G00 Rapid
motion until it is changed in Gcode.
v5.18 - 08 Apr,2021
www.masso.com.au Page 217 of 477
To Next Page
Loading...
