MASSO
MASSO Documentation
More information on connect your Plasma on/off can be found here:
Hypertherm 45, 65 & 85
THC installation
A THC is not required for Plasma but it is helpful in keeping the torch the required distance from the material
you are cutting. The distance you keep the torch above the material will influence the quality of the cut and
since metals are subject to warping and can be bent a THC will keep the distance you set constant.
The installation of a THC onto your MASSO is covered separately under the section
How THC Works
This will give you take you through the basic principals of how the THC interfaces with MASSO and explains
the Gcode commands specific to the THC functionality
The document also shows examples of the 2 methods of connecting your THC to MASSO and explains why
one method is preferred over the other.
v5.18 - 08 Apr,2021
www.masso.com.au Page 171 of 477
To Next Page
Loading...
Need help?
General
