MASSO
MASSO Documentation
Spindle uses 0-10 volt signal to control speed normally via a VFD.
If your spindle does not have speed control you can still do threading as the spindle encoder will
track spindle speed for the threading operation however constant surface speed will not function as
this requires active speed control.
Spindle control
Spindle Encoder
The spindle encoder is used for threading cycles.
Please read and understand the information on the Spindle encoder page. Pay special attention to the
maximum frequency allowed and stay below this value.
Information on installing your encoder can be found using the link below.
Spindle Encoder
Lathe Tool Calibration
Follow the link below to learn more about the Lathe tool calibration process.
Tool Calibration Process
v5.18 - 08 Apr,2021
www.masso.com.au Page 180 of 477
To Next Page
Loading...
