MASSO
MASSO Documentation
Tool Setter Logic
The normal state for the tool setter when not active must be LOW as shown below or it will not work.
If your input shows HIGH then highlight the input by clicking with the mouse and press the Spacebar
to invert the logic to show LOW.
Manual Tool Change
The Tool setter can be used with manual tool change as well as automatic tool changers.
When you manually change a tool MASSO will move to the Tool Setter and touch off. It will then
automatically calculate the new tool height and continue machining having compensated for the difference in
tool height.
How to Video
This video takes you through setting up a Tool setter step by step.
Scan the QR code to watch the MASSO video tutorial on YouTube
Or, Click here to view the video
v5.18 - 08 Apr,2021
www.masso.com.au Page 397 of 477
To Next Page
Loading...
