MASSO G2 User Manual

MASSO
MASSO Documentation
6.6.9. Resetting Job Counter
.............................................................................................. 99
6.7. Loading & Running G-Code
....................................................................................... 100
6.8. Resuming Program or Jump to Line
............................................................................ 101
6.9. Wi-Fi Connectivity
..................................................................................................... 103
6.9.1. MASSO Link Software
............................................................................................ 110
6.9.2. MASSO Link - macOS Instructions
............................................................................ 111
6.9.3. MASSO Link - Windows Instructions
.......................................................................... 116
6.9.4. MASSO Link - Linux Instructions
............................................................................... 117
6.10. Calibrating Tools
..................................................................................................... 118
6.10.1. Lathe Tool Calibration Steps
.................................................................................. 119
6.10.2. Mill Tool Calibration Steps
..................................................................................... 127
6.11. Work Offsets
........................................................................................................... 130
6.12. Conversational Programming
................................................................................... 131
6.12.1. Lathe Conversational Wizards
................................................................................ 132
6.12.2. Mill Conversational Wizards
................................................................................... 138
6.13. Auto Loading G-code
............................................................................................... 143
6.14. Probing
................................................................................................................... 145
7. Quick Start Guides ...................................................................................................... 148
7.1. Safe work practices when wiring MASSO
.................................................................... 149
7.2. Setup MASSO Mill
..................................................................................................... 153
7.3. Setup MASSO Plasma
.............................................................................................. 164
7.4. Setup MASSO Lathe
................................................................................................. 172
7.5. Setup Rotary Axis
..................................................................................................... 181
7.6. Homing Sensor Identify & Connect
............................................................................. 185
8. Supported G-codes ..................................................................................................... 193
8.1. G00 - Rapid Motion
................................................................................................... 194
8.2. G01 - Linear Interpolation Motion
................................................................................ 195
8.3. G02 – Circular Interpolation (Clockwise)
...................................................................... 196
8.4. G03 – Circular Interpolation (Counter Clockwise)
......................................................... 198
8.5. G04 – Dwell
.............................................................................................................. 201
8.6. G10 – Set Work Offset Values
.................................................................................... 202
8.7. G17 – XY Plane Selection
.......................................................................................... 203
8.8. G18 – ZX Plane Selection
.......................................................................................... 204
8.9. G19 – YZ Plane Selection
.......................................................................................... 205
8.10. G20 – Set Machine Units To Inches
.......................................................................... 206
8.11. G21 – Set Machine Units To Millimetres
.................................................................... 207
8.12. G28 – Return To Machine Home
.............................................................................. 208
8.13. G30 - Move to Parking Position
................................................................................ 210
8.14. G32 – Threading Cycle
............................................................................................ 212
8.15. G38.2 – Straight Probe Cycle
................................................................................... 213
8.16. G53 – Move In Absolute Machine Coordinates
........................................................... 214
8.17. G54 to G59 – Select Work Offset Coordinate System
................................................. 215
8.18. G73 – High Speed Peck Drilling
................................................................................ 216
8.19. G80 – Cancel Modal Motion
..................................................................................... 217
8.20. G81 – Drilling Cycle
................................................................................................. 218
v5.18 - 08 Apr,2021
www.masso.com.au Page 4 of 477

MASSO G2 Specifications

General

Brand	MASSO
Model	G2
Category	Controller
Language	English