MASSO
MASSO Documentation
THC input settings. Note these are not inverted
Setting up the MASSO output
Assign the MASSO output of your choice as Plasma On/Off Signal. On the MASSO G3 this will be a
TTL output and will connect to a TTL relay board such as the
MASSO TTL relay module.
On the MASSO G2 you can use either a TTL relay as with the G3 on one of the 16 TTL outputs or
you can use one of the 6 Relay outputs and connect a suitable relay direct to the output.
How to connect a suitable relay direct to the output
Wire the normally open or normally closed contact from the relay to the Plasma unit in accordance
with the manufacturers instructions. This is used to turn the torch on and off as needed under control
of the M3 / M5 commands.
In the example below the normally closed contact is used and output 18 is configured as Plasma on / off.
v5.18 - 08 Apr,2021
www.masso.com.au Page 457 of 477
To Next Page
Loading...
