2 - 74
2.14 Operator Authentication
(c) Password expiration date
Touch [Password expiration date], and then the Password
expiration date edit dialog is displayed. Input the expiration
date.
When the input is completed, touch the [Enter] key.
(d) Initial position input
Set the initial position input (byte count) of external
authentication ID from among the data read from the
external authentication device.
(e) Valid byte count input
Set the valid byte count for external authentication ID.
(Only available when the external authentication (general)
is set as the authentication method.)
(f) Continuous failure count to block login
Set the maximum number of failed login attempts.
(g) Login prohibition time
Set a period of time to block login.
If the maximum number of failed login attempts is
exceeded, login is blocked for the set period of time.
Log in again after the login prohibition time elapses.
(h) Continuous failure count to lock an operator ID
If the maximum number of failed login attempts is
exceeded, a target operator ID is locked.
For information on how to unlock an operator ID, refer to
the following.
➠ (b) Edit operation
Step 4. Touch the [OK] button after all items are input, and then the
dialog shown left is displayed and the input setting is saved.
Step 5. If you touch the [×] button without touching the [OK] button,
the dialog on the left is displayed
To Next Page
Loading...
Need help?
General
