MUTOH ValueJet 1604 - 5.13.3 Pump Endurance Menu

5 Self-Diagnosis Mode VJ-1604 Maintenance Manual
Rev.-05 5-68
5.13.3 Pump Endurance Menu
This menu performs endurance running for the pump motor assembly.
You can drive the pump motor assembly according to your desired settings. The available settings are shown
below.
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Table 5-24 Set Items in Pump Motor Assembly Endurance Menu
Set item Contents Set value Remark
Running speed Set the running speed of
pump motor assembly.
Super high / High /
Normal / Low
Number of endurance
running cycles
Set the number of endurance
running cycles.
-1 to 10000
[Enter] or [Cancel ]
[Enter]
[<] key
[<] key
[>] key
[<] key
[>] key
[<] key
[>] key
[>] key
[Enter]
[Enter]
[Enter]
[Enter]
Endurance Count
Performing Endurance
[Enter]
[Enter]