7 Adjustment VJ-1604 Maintenance Manual
Rev.-05 7-32
7.7 CR Speed Reduction Belt Tension Adjustment
This section describes the procedure to adjust the tension of the CR speed reduction belt.
When you have removed and installed the CR speed reduction belt, adjust the CR speed reduction belt
tension.
7.7.1 Jigs and Tools
The jigs and tools required for CR speed reduction belt tension adjustment are as follows.
• Tension gauge: for measuring Max. 40N (4080gf)
"8.4 Jigs and Tools" p.8-5
7.7.2 Adjustment Procedures
1. Remove the side maintenance cover R.
"4.2.4 Removing Side Maintenance Cover R" p.4-11
2. Remove the side top cover R.
"4.2.6 Removing Side Top Cover R" p.4-12
3. Remove the panel to conversion board tape wire from the flat cramps (2 pieces) on the back of the
cartridge cover stay R.
No. Part name
1 CR motor assembly
2 Cartridge cover stay R
3 Panel to conversion board tape wire
4 Flat cramp
1
3
2
4
To Next Page