MUTOH ValueJet 1604 - Errors with Message

VJ-1604 Maintenance Manual 9 Troubleshooting
9-5 Rev.-05
9.2.2 Errors with Message
This section describes the contents of errors with messages as well as the check items and recovery actions.
These messages are displayed when an abnormal condition occurs while the machine is running.
Upon an occurrence of an error with message, the machine stops its operation at the same time.
The error can be cancelled by removing the error causes. After that, the machine will restart its operation.
3 7. Main board
assembly may be
damaged.
Replace MAIN board
assembly.
"4.4.7
Replacing
MAIN
Board" p.4-
49
Table 9-3 Symptoms and Check Items for Errors with Message
No. Message Event/
symptom
Check item Action Reference
1Media
detection error
Media
detection failed
1. Is P_EDGE sensor
assembly cable at
head connected
correctly?
Securely connect it to
CR board assembly
connector J208.
"4.8.3
Replacing CR
Board
Assembly"
p.4-107
2. Is P_REAR sensor
under media guide
R connected
correctly?
Securely connect it to
MAIN board assembly
connector J42.
"4.4.7
Replacing
MAIN
Board" p.4-
49
3. Check sensor
sensitivity from
"Sen 8:EdgeAD" of
self-diagnosis
function.
• Adjust with MAIN
board assembly
volume (R361,
R365).
• Replace P_EDGE
sensor assembly.
"7.10
P_EDGE
Sensor
Sensitivity
Adjustment"
p.7-41
4. Is CR cable inserted
obliquely?
Reconnect following
connectors.
• Main board
assembly: J9 - J11
• CR board: J201 -
J205
"4.4.7
Replacing
MAIN
Board" p.4-
49
"4.8.3
Replacing CR
Board
Assembly"
p.4-107
5. CR cable assembly
may be broken.
Replace CR cable
assembly.
"4.7.8
Replacing
CR_FFC"
p.4-100
Table 9-2 Events and Check Items for Operation Status Messages(Continued)
No. Message Event/
symptom
Check item Action Reference