MUTOH ValueJet 1604 User Manual

VJ-1604 Maintenance Manual 7 Adjustment
7-9 Rev.-05
7.3.1 Parameter Backup
The NVRAM (Flash-ROM) installed on the MAIN board assembly stores various parameters for the system
operation.
The available backup parameters are as follows.
• Panel setting parameters
• Mechanism adjustment parameters
• Main board-unique adjustment parameters
The MAIN board-unique adjustment parameters cannot be erased or modified.
If the MAIN board assembly is found to need replacement during maintenance operations, make sure to back
up the parameters. The backup data can be used to restore the original system status, omitting some
adjustment steps.
7.3.2 Jigs and Tools
The following jigs and tools are required for parameter backup.
•Windows PC:
• CPU: Pentium 400MHz or higher, Installed memory: 128MB or more
• With one of the following installed: Windows 98 SE / Windows Me / Windows 2000 / Windows XP
䎰
䎰
Set IP Address of PC
Execute Board Manager mode
Install Firmware
Confirm Firmware installation
䎰
Operation using MUTOH Maintenance
Engineer Assistant
䎳
䎰
䎳
䎳
Operation using operation panel
Confirm IP Adress of Printer
End
Workflow for Firmware installation (Version-up Procedure)

MUTOH ValueJet 1604 Specifications

General

Brand	MUTOH
Model	ValueJet 1604
Category	Printer
Language	English