MUTOH ValueJet 1604 - 5.13.5 General Endurance Menu

5 Self-Diagnosis Mode VJ-1604 Maintenance Manual
Rev.-05 5-70
5.13.5 General Endurance Menu
This menu performs the general endurance running.
You can operate various driving systems according to your desired settings.
The available settings are shown below.
• In the general endurance menu, the following operations are performed as one cycle of endurance
running:
• Carriage stroking: 1 stroke
• Media feed: 1 cycle
• If the number of endurance running cycles is set to -1, the carriage continuously repeats stroking
until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Table 5-26 Set Items in General Endurance Menu
Set item Contents Set value Remark
Running speed (CW,
CCW)
Set the carriage running
speed (CW direction,
CCW direction).
240, 320, (400)
* 400 cps cannot be
selected depending on
versions.
Unit: cps
Media feed amount Set the media feed
amount per endurance
running cycle.
0.1 to 100 Unit: mm
Number of endurance
running cycles
Set the number of
endurance running
cycles.
-1 to 10000 -
CW-speed
CCW-speed
Media feed amount
Endurance count
[Enter]
[Enter]
[Enter]
[Enter]
[Enter] or [Cancel]
Performing endurance running
[Enter]
[Enter]