VJ-1604　 Maintenance Manual 1 Safety Instructions
1-3 Rev.-05
1.3 Important Safety Instructions
General safety instructions that must be observed to use the equipment safely are explained below.
Do not install this printer in the following locations:Doing so may result in the printer
tipping or falling over and causing injury.
• Unstable surfaces
• Angled place
• Areas subject to vibration by other equipment
Do not stand on or place heavy objects on your printer. Doing so may result in the
printer tipping or falling over and causing injury.
Do not cover the ventilation hole of your printer with cloth, such as a blanket or table
cloth. Doing so may result in fire.
Do not place the printer in humid and dusty areas. Doing so may result in electrical
shock or fire.
Do not use damaged power supply cables. Doing so may cause electric shock or
fires.
Do not connect or disconnect the power supply plug with wet hands. Doing so may
cause electric shock.
Make sure that the following is performed before parts replacement.
• Turn off the power of the printer.
• Remove the power cable from the power outlet.
Not doing so may cause electric shock or damage to the electric circuit.
• Unplug the cables connected to the printer.
Failure to do so could result in damage to the printer.
Do not connect ground lines to the following locations.
• Gas piping
There will be a possibility of causing fires or exploding.
• Phone ground lines and lightning rods
A large current may flow if there is a lightning strike.
• Water piping and faucets
If a part of the piping is plastic, it will not serve as a ground.
During heater operation, do not place flammable objects on top of the platen. Doing
so may cause fires.
Do not spill flammable fluids on the platen. Doing may cause fires.
To Next Page
Loading...
Need help?
General