3 Specifications VJ-1604 Maintenance Manual
Rev.-05 3-2
3.1 Introduction
This chapter explains the specifications of the product, optional parts, and supplies. Installation environment
requirements are also explained.
3.2 Product Specifications
(1) Main Unit Specifications
Item Specifications
Model name
VJ-1604
Plotting method
On-demand piezo drive
Motor driving method
Firmware servo / DC motor drive
Media feeding method
Multi-point pressure grid roller method
Media fixing method
Pressurizing roller manual-down method
Media supply and
ejection
Roll media
Rear feeding / front ejection
Roll media outer diameter
150 mm (5.9 in.) or less
Roll media weight
30 kg (66 lb.) or less
Maximum media length
50 m (164 ft.)
Maximum media width
1625 mm (63.9 in.)
Maximum media thickness
0.3 mm (0.01 in.)
Maximum plot length
18 m (59.1 ft.)
Maximum plot width
1615 mm (63.6 in.)
Plotting margins
Top: 15 mm, Bottom: 5 mm, Left: 5-25 mm, Right: 5-25 mm
Media cutting method
Horizontal manual cut
Head height adjustment
2 levels: Normal / High
Distance accuracy The larger value either ± 0.25 mm or ± 0.1% of moving distance
•Used media: Roll MF-3G
• Plot length: 1219 mm (4 ft.)
• Operating temperature: 22ºC to 30ºC (71.6ºF to 86ºF)
• Operating humidity: 40% to 60%
•PG: Low
• Plot mode: Graphics1
Right angle accuracy ±0.1 mm or less against the moving distance (500.0 mm)
•Used media: Roll MF-3G
• Operating temperature: 22ºC to 30ºC (71.6ºF to 86ºF)
• Operating humidity: 40% to 60%
• Plot mode: Graphics1
CPU
64Bit RISC CPU
Memory
256MB
To Next Page
Loading...
