Configure Automatic wake-up
Introduction
You can use Automatic wake-up to start up the printer automatically each workday. The
wake-up time and workdays are configurable.
Illustration
How to configure Automatic wake-up
1.
Open the 'Preferences' - 'System defaults' tab.
2.
Click on 'Edit' in the 'Printer properties' section or click on the 'Automatic on' setting.
3.
If you enable the setting, you must also enter the following settings in the 'Printer prop-
erties' section: 'Start-up time', 'End of workday time', 'First workday' and 'Last workday'.
4.
Click on 'Ok' to confirm or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools164
Configure Automatic wake-up
To Next Page
Loading...
Need help?
General