Set the 'PDF wipeout correction'
Introduction
The 'PDF wipeout correction' setting allows you to print PDF documents that contain
solid black areas that block parts of the image. If you enable this setting, PDF documents
are printed correctly but the processing of the PDF files is slower.
Before you begin
For this procedure, you need to log in as a Key Operator.
How to set the 'PDF wipeout correction'
In Océ Express WebTools:
1.
Open the 'Preferences' - 'Print job defaults' tab.
2.
Click on 'Edit' in the 'Postscript/PDF rasterization settings' section or click on the 'PDF
wipeout correction' setting.
3.
Select the correct value. The setting is enabled when you check the box.
4.
Click 'Ok' to confirm or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools178
Set the 'PDF wipeout correction'
To Next Page
Loading...