Configure the media sizes
Introduction
You can load various media sizes on the printer. In Océ Express WebTools, you can in-
dicate the various media sizes to make them recognizable for the printer.
Note:
For this procedure, you need to log in as a System Administrator.
How to define the media sizes
In Océ Express WebTools:
1.
Open the 'Support' - 'Media' tab.
2.
Click on the 'Supported media sizes' setting. A new window opens.
3.
Select a media series from the list. For each of the standard media series ('ANSI small',
'DIN', 'ANSI mixed' or 'DIN Carto') a set of media sizes is enabled.
4.
You can enable or disable media sizes to tune the system to your environment. The media
series will then automatically change into a 'Custom' media series.
5.
Click 'Ok' to confirm or 'Cancel' to reject your entries.
Note:
You cannot disable media sizes that are currently loaded on the printer.
Note:
When you load a media roll the printer automatically detects the roll width. If the detected
roll width is not a standard width, the printer selects the next smaller roll width that is
supported by the printer.
Note:
When you load a media roll with a size that was not yet enabled in the media series, the
system automatically adds the new media size to the custom media series.
Chapter 3 - Define your Workflow with Océ Express WebTools 167
Configure the media sizes
To Next Page
Loading...
Need help?
General