Set the link speed and duplex mode
Introduction
Use Océ Express WebTools to set the transmission speed and duplex mode for your
network adapter.
Before you begin
Note:
For this procedure, you need to log in as a Key Operator.
Note:
The list of values you can select depends on the network card type.
Set the network speed and duplex mode
In Océ Express WebTools:
1.
Open the 'Configuration' - 'Connectivity' tab.
2.
Click on 'Edit' in the 'Network adapter' section or click on the 'Link speed and duplex
mode' setting.
3.
Select the correct value. 'Automatic detection' is default. If automatic detection fails, you
must select the value that matches the properties of your local network.
4.
Click 'Ok' to confirm or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools184
Set the link speed and duplex mode
To Next Page
Loading...