Move and re-adjust the printing system
Introduction
If you move the printing system to a new location, you must check if it needs readjustment
to ensure the best output quality.
You need two tools for the adjustment procedure. You can find these tools behind the
lower right front cover.
Required tool
•
Allen wrench
•
Key wrench
Attention:
When the printer is connected, you must first turn off and disconnect the printer (see
‘Turn off the printing system’ on page 286 and ‘Disconnect the network cable and the mains
supply cable’ on page 288).
Attention:
Close the media drawers.
Note:
Be aware of the size of the printer working area (see ‘Working area [Footprint]’ on page
23).
1.
Move the printing system to its new location.
Chapter 5 - Maintain the Printing System 289
Move and re-adjust the printing system
To Next Page
Loading...
Need help?
General