Océ PlotWave 340 - Connect the mains supply cable and the network cable

Connect the mains supply cable and the network cable
Attention:
Make sure the power switch(B) is in the off position.
1.
Plug the power supply cable into the power connection at the back of the printer (A) (on
the left-hand side).
A
B
C
2.
Plug the other side of the mains supply cable into the wall socket.
3.
Plug the network cable into the network connection (C) at the back of the printer (on
the right-hand side) to connect the printer to your company network.
Chapter 5 - Maintain the Printing System 295
Connect the mains supply cable and the network cable
Operating Information: PlotWave (PW) 340, PW350 - Edition 2013-06