Set the 'Alignment' mode
Introduction
If you want shift the image on the sheet, you can change the alignment mode. With the
alignment mode, you can also optimize the print productivity as you reduce the distance
the print carriage has to travel. You can, for instance, align the image to the top right-
hand corner of the sheet.
You can choose the following alignment settings:
#
'Alignment' mode
'Top right''Top''Top left'
'Right''Center''Left'
'Bottom right''Bottom''Bottom left'
Before you begin
For this procedure, you need to log in as a Key Operator.
How to set the alignment mode
In Océ Express WebTools:
1.
Open the 'Preferences' - 'Print job defaults' tab.
2.
Click on 'Edit' in the 'Layout' section or click on the 'Alignment' setting.
3.
Select the correct value.
Select 'Top right' if print productivity is the most important factor.
4.
Click 'Ok' to confirm or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools 183
Set the 'Alignment' mode
To Next Page
Loading...
Need help?
General