Do a default scan job
Introduction
When you want to scan an original and you do not make any settings, the default presets
are used. You only use the Smart Access to submit your job.
You can see the presets that are used in the job settings section of your job.
Illustration
Do a default scan job
1.
Feed the original face up and centered on the original feeding table.
Note:
You do not need to center the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
Chapter 4 - Use the Printing System254
Do a default scan job
To Next Page
Loading...
Need help?
General