Oki IP-6620 - Page 242

242
Troubleshooting
PH TEMP IS TOO HIGH
PRINT? OK/CANCEL
Meaning
The print heads temperature exceeds the printer operating range.
Action
Secure an ambient temperature between 15 and 30°C to prevent an
increase in the print heads temperature.
Press the OK button to start the printing.
You may also press the CANCEL button to suspend the printing.
PH COOLING PROCESS
STANDARD ND BI
Meaning
The printer monitors the print heads temperature to make sure the
ink is ejected in a stable manner. If the temperature exceeds 40°C, a
protection mechanism is triggered and the printing is suspended.
Action
Secure an ambient temperature between 15 and 30°C to prevent
an increase in the print heads temperature. The printing resumes
automatically after the print heads temperature has decreased.
<Communication errors>
NO DATA RECEIVED
CHECK CONNECTION
Meaning
During the print data transfer, a USB connection failure or cable
disconnection was detected.
Action
Check the USB cable connection.
DATA COMMUNICATION
WAS INTERRUPTED
Meaning
Though a timeout occurs during the print data transfer, its cause is not a
printer failure.
Action
Check the USB cable connection.
<Other errors>
CLOSE COVERS
Meaning
The front cover is open.
Action
You are advised to follow the message instructions.
PRIME INK SYSTEM
Meaning
Cleaning or printing was started before priming the ink system.
Action
Prime the ink system before starting cleaning or printing.
MANUALLY ADJUST n
ADV VAL/PRINT POS
n: Error code
Meaning
Automatic print adjustment could not be performed.
Action
You are advised to follow the message instructions.
(See When automatic print adjustment cannot be performed on
page 83.)
INSTALL WIDER MEDIA
Meaning
Media of less than 762 mm (30 inches) in width was installed when
automatic nozzle map was performed.
Action
Use media of 762 mm (30 inches) or larger when performing automatic
nozzle map.
(See When an error occurs with automatic conguration on
pa ge 113.)
MANUALLY CONFIGURE n
NOZZLE MAPPING
n: Error code
Meaning
Automatic nozzle map could not be performed.
Action
You are advised to follow the message instructions.
(See When an error occurs with automatic conguration on
pa ge 113.)