Omron R88D-1SN ECT Series User Manual

1
Introduction
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User’s Manual (I586)
Introduction
Thank you for purchasing a 1S-series Servo Drive. This User’s Manual describes the installation and
wiring methods of the 1S-series Servo Drives and parameter setting method which is required for the
operation, as well as troubleshooting and inspection methods.
This User’s Manual is intended for the following personnel, who must also have electrical knowledge
(certified electricians or individuals who have equivalent knowledge).
• Personnel in charge of introducing the FA equipment
• Personnel in charge of designing the FA systems
• Personnel in charge of installing and connecting the FA equipment
• Personnel in charge of managing the FA systems and facilities
This User’s Manual contains information you need to know to correctly use the 1S-series Servo Drives
and peripheral equipment.
Before using the Servo Drive, read this User’s Manual and gain a full understanding of the information
provided herein.
After you finished reading this User’s Manual, keep it in a convenient place so that it can be referenced
at any time.
Make sure this User’s Manual is delivered to the end user.
Intended Audience
Notice

Omron R88D-1SN ECT Series Specifications

General

Feedback	Incremental encoder, Absolute encoder
Position Control	Yes
Speed Control	Yes
Torque Control	Yes
Communication Interface	EtherCAT
Power Supply Voltage	200 to 240 VAC
Output Power	0.1 to 1.5 kW
Input Voltage Range	170 to 264 VAC
Control Method	Sine-wave PWM control
Main Circuit Power Supply	200-240 VAC
Applicable Motor Capacity	0.1 to 1.5 kW
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Encoder Error
Ambient Operating Temperature	0 to 55°C
Vibration Resistance	4.9 m/s² (10 to 55 Hz)
Shock Resistance	98 m/s2
Weight	Varies by model