and test the system to those requirements. If you have questions, contact
your Philips representative.
• Do not use nonmedical peripherals, such as report printers, within 1.5 m
(5 ft) of a patient, unless the nonmedical peripherals receive power from
an isolated power outlet on the Philips ultrasound system, or from an
isolation transformer that meets medical safety standards, as defined by
standard IEC 60601–1.
1. Turn off the system and unplug the power cord from the power source.
2. Connect a standard USB cable between the USB port on the printer and a
USB port on the system.
• If your system has two USB ports on the back of the system behind the
DVD drive, you can connect the printer cable to one of those ports or
one of the USB ports on the lower rear of the system.
• If your system has one USB port on the back of the system behind the
DVD drive, you must connect the printer to one of the two ports on the
USB hub located above the top peripheral bay.
3. Connect the printer’s power cord into the back of the printer, and plug the
other end into an appropriate power source (see "Warnings" on page 17).
4. Turn on the printer, and then turn on the system.
The system installs the printer drivers automatically.
5. After the system installs the new printer drivers, restart the system.
iU22 User Manual
110
4535 614 45861
Preparing the System
4
To Next Page
Loading...
