the touch screen, and plastic and painted surfaces. The following products can
be used on system surfaces:
• Mild soap solution
• 70% isopropyl alcohol (IPA)
• T-Spray II (quaternary ammonium-based)
• Opti-Cide-3 (quaternary ammonium/isopropyl alcohol-based)
• Sani-Cloth HB (quaternary ammonium-based)
• Sani-Cloth Plus (quaternary ammonium/isopropyl alcohol-based)
Other products that are based on quaternary ammonium compounds (QUAT)
or QUAT/isopropyl alcohol can also be used in disinfecting system surfaces.
Disinfecting System Surfaces
WARNING
Always use protective eyewear and gloves when cleaning and disinfecting any
equipment.
CAUTIONS
• Use only compatible disinfectants on system surfaces.
• If you use an isopropyl alcohol solution for disinfection, ensure the solution
is only 70% alcohol or less. Solutions of more than 70% alcohol can cause
product damage.
Before performing this procedure, read "Disinfectants for System Surfaces" on
page 313.
1. Turn off the system and disconnect the system power cord from the wall
outlet.
2. Use a soft cloth lightly dampened in a mild soap or detergent solution to clean
exterior surfaces on the system.
3. Mix the disinfection solution compatible with your system according to label
instructions for solution strength.
iU22 User Manual
314
4535 614 45861
System Maintenance
14
To Next Page
Loading...