Moving the System
Observe the following warnings and cautions before moving the system.
WARNINGS
• Be aware of the wheels, especially when moving the system. The system
could cause injury to you or others if it rolls over feet or into shins. Exercise
caution when going up or down ramps.
• When attempting to overcome an obstacle, do not push the system from
either side with excessive force, which could cause the system to tip over.
• Position external hardcopy devices away from the system. Ensure that they
are secure. Do not stack them on the system.
• When positioning the articulated monitor, move it carefully to avoid pinching
hands or extremities against other objects, such as a bed rail.
• Never park the system on an incline.
• The brakes are intended as a convenience. To increase cart security, use
wheel chocks when the system is parked.
• Before moving the system, ensure that the keyboard is retracted, the control
panel is centered, and the monitor is locked. When extended, the keyboard
might be damaged if it hits another object, and the video monitor could
swing out during transport, causing injury or equipment damage.
CAUTIONS
• Before moving the system, ensure that the brakes are completely released
(by fully lifting the brake pedal). Otherwise, the engaged brake pad can
damage the rubber casters on the wheels.
• Ensure that the cables for all patient-applied parts are secure before moving
the system. Use the cable management system to ensure that transducer
cables are protected from damage.
• Do not roll the system over transducer cables or power cables.
• When transporting the system in a vehicle, avoid exposing the monitor to
direct sunlight and do not let the inside temperature of the vehicle exceed
65°C (149°F). Either of these conditions can permanently damage the
monitor.
iU22 User Manual
116
4535 614 45861
Preparing the System
4
To Next Page
Loading...