Connecting Transducers
The system includes three receptacles for array transducers and one receptacle
for a pulsed- or continuous-wave Doppler probe.
1. Turn the locking lever counter-clockwise.
2. Set the transducer in one of the transducer holders on either side of the
control module.
3. Hang the transducer cable on the cable management bracket below the control
module.
4. Insert the transducer connector into one of the three receptacles on the
front of the system.
5. Turn the locking lever clockwise.
iU22 User Manual
164
4535 614 45861
Using the System
5
To Next Page
Loading...