Grayscale or color bar4
Focal indicator5
TGC curve6
Depth7
Image area8
Setting the Auto Freeze Function
The Auto Freeze function stops imaging and freezes the image, if a control is
not manipulated within the Wait time that you specify. The default time is 5
minutes. After Auto Freeze has been invoked, press any control to restart
imaging.
1. Press the Setup key.
2. Click System Settings.
3. Click the Display tab.
4. Under Auto Freeze, select On, and then select the Wait time.
5. Click Done.
Transducer Receptacles and Cable Management
The system includes three receptacles for array transducers and one receptacle
for a pulsed- or continuous-wave Doppler probe. All four receptacles can be
occupied at the same time, but only one transducer can be active at a time.
When a transducer is not in use, store it in one of the transducer holders on
the control module.
When a transducer is not in use, store it in one of the transducer holders on
the control module. Always use the cable management system to prevent cables
from being stepped on or run over by the cart wheels.
iU22 User Manual
162
4535 614 45861
Using the System
5
To Next Page
Loading...