To reduce the presence of glutaraldehyde fumes in the air, be sure to use a
covered or ventilated soaking basin. Such systems are commercially available.
The most-current information about disinfection products and Philips transducers
can be found on the Philips Transducer Care Web site:
www.healthcare.philips.com/us/products/ultrasound/transducers/transducer_care/
Infection Control
Issues related to infection control affect the operator and the patient. Follow
the infection-control procedures established in your facility for the protection
of both the staff and the patient.
Handling Contaminated Transducers
The primary area of concern is the handling of transducers that have contacted
infected patients. Always wear gloves when you handle transducers used in TEE,
endocavity, intraoperative, and biopsy procedures that have not been previously
disinfected.
For information on cleaning and disinfecting transducers, see the "Transducer
Care" section.
Removing Blood and Infectious Material from the System
CAUTION
Do not wipe the transducer housing joint, strain relief, or cable with isopropyl
alcohol. Isopropyl alcohol can damage these parts of the transducer. This damage
is not covered by the warranty or your service contract. Also, do not use
isopropyl alcohol on TEE transducers (except for their handles).
Use a gauze pad moistened with soap and water to remove blood on the system
and the transducer connectors and cables. Then dry the equipment with a soft
cloth to prevent corrosion. You can use a 70% solution of isopropyl alcohol on
the system and only on certain parts of some transducers. Additional cleaning
agents are available for transducers. For more information, see the "Transducer
Care" section.
iU22 User Manual
66
4535 614 45861
Safety
2
To Next Page
Loading...