problem persists, move the ultrasound system to another room at least 30 m
(100 feet) away and check communications again. Turning off all other wireless
devices can help you locate the source of the interference.
Troubleshooting Voice Controls
If the error message "The system failed to communicate..." displays during the
use of voice control, use the following procedure to correct the problem.
1. Ensure headset is turned on.
2. Ensure headset is paired to system.
3. Refresh the Active Headsets list and select your headset again.
NOTE
If the problem persists or is not covered here, contact your Philips Ultrasound
customer support representative.
Using Voice Commands
You can use voice control regardless of whether you have created and trained
a voice profile. However, Philips recommends that you create and train a voice
profile before using voice control. Training voice control to recognize your
speech significantly improves recognition accuracy. Minimally training a voice
profile requires only about 2 minutes.
For a list of voice commands, see the Voice Control Quick Guide.
NOTE
Always wear the headset on the ear closest to the system. Wearing it on the
other ear reduces the range of the headset.
1. If you have not used voice control since the system was powered up, perform
the procedure in "Enabling Voice Control" on page 147.
2. Do any of the following to use voice control:
iU22 User Manual
152
4535 614 45861
Using the System
5
To Next Page
Loading...