When using multiple headsets in one location, it is important to give each headset
a unique name and to label each headset with its name. To locate the controls
on the headset, see the documentation provided with the headset.
NOTE
When a new headset is paired to the system, it may be necessary to pair the
headset twice. After you have paired it once, click Unpair to unpair it, turn the
headset off and on again into pair mode, and then pair it a second time.
1. Press the Setup key.
2. Click Voice Control, and then click the Headset Config tab.
3. Wait until the message "Querying headsets" disappears from the bottom of
the display, indicating that the system is finished querying headsets.
4. Ensure that the headset is off.
5. Press and hold the Call Handling button on the headset until the indicator
lights as described in the headset documentation. The headset is now in pair
mode.
6. Click Refresh Current Status.
7. Select the headset in the list:
• For a Sony Ericsson headset, select the name that starts with HBH.
• For a Jabra headset, select the name that starts with Jabra.
• For a Plantronics headset, select the name that starts with PLT.
8. Click Pair.
9. At the prompt, type the passkey (0000) and click Next. If 0000 does not
work, use the passkey shown in the headset documentation.
10. If the model number of the selected headset is listed under Name, rename
the headset with a unique name by doing the following:
a. Click Change Name.
b. Type a unique name.
c. Click OK.
11. Click Done.
12. Label the headset with the name you assigned to it in step 10.
145
iU22 User Manual
4535 614 45861
5
Using the System
To Next Page
Loading...