Philips MP2 - Cleaning the Monitor; Disinfecting the Equipment

20 Care and Cleaning
246
Cleaning the Monitor
Clean with a lint-free cloth, moistened with warm water (40°C/104°F maximum) and soap, a diluted
non-caustic detergent, tenside, ammonia- or alcohol-based cleaning agent. Do not use strong solvents
such as acetone or trichloroethylene.
Take extra care when cleaning the screen of the monitor because it is more sensitive to rough cleaning
methods than the housing. Do not permit any liquid to enter the monitor case and avoid pouring it on
the monitor while cleaning. Do not allow water or cleaning solution to enter the measurement
connectors. Wipe around, not over, connector sockets.
CAUTION
To clean the touch-enabled display, disable the touch operation by switching off the monitor during
the cleaning procedure, or by pressing and holding the Main Screen key for two seconds. Press the
Main Screen key again to re-enable touch operation.
Recommended cleaning agents are:
Disinfecting the Equipment
CAUTION
Solutions: Do not mix disinfecting solutions (such as bleach and ammonia) as hazardous gases may
result.
Clean equipment before disinfecting. Recommended types of disinfecting agents are:
Tensides (dishwasher detergents) Edisonite Schnellreiniger
®
, Alconox
®
Ammonias Dilution of Ammonia <3%, Window cleaner
Alcohol Ethanol 70%, Isopropanol 70%, Window cleaner
Product Name Product Type Ingredients
Isopropanol liquid Isopropanol 80%
Bacillol
®
AF liquid, spray 100 g concentrate contains:
Propan-1-ol 45.0 g;
Propan-2-ol 25.0 g;
Ethanol 4.7 g
Bacillol
®
25 liquid Ethanol 100 mg/g
Propan-2-ol (= 2-Propanol) 90 mg/g;
Propan-1-ol (= 1-Propanol) 60 mg/g
Meliseptol
®
spray 50% 1-Propanol
Accel TB RTU liquid 0.5% accelerated hydrogen peroxide
Oxivir
®
Tb Cleaner Disinfectant spray 0.5% accelerated hydrogen peroxide
Oxivir
®
Tb Wipes wipes 0.5% accelerated hydrogen peroxide