1 Basic Operation
36
The cableless measurement device is now added to the monitor.
If the corresponding internal measurement in the patient monitor is active, you will be asked to
confirm that it should be deactivated in favor of the cableless measurement device by selecting
Replace.
If a cableless measurement of the same type is already assigned to the monitor, you will be asked to
confirm that it should be removed by selecting
Replace.
Adding Manually
1 Prepare the SpO
2
or NBP Pod for adding by holding the ◄ key pressed, or the Respiration Pod by
pressing the hardkey.
2 Select the device key that appears in place of the Measurement Selection key, for example
.
This displays the
Add Cableless window, that shows any available IntelliVue Cableless
Measurements and telemetry devices:
3 Select the cableless measurement device to be added.
4 Select Add. The device confirms the successful addition with a tone.
If the corresponding internal measurement in the patient monitor is active, you will be asked to
confirm that it should be deactivated in favor of the cableless measurement device by selecting
Replace.
If a cableless measurement of the same type is already assigned to the monitor, you will be asked to
confirm that it should be removed by selecting
Replace.
For the SpO
2
and NBP Pods, adding can also be done directly on the device. See the IntelliVue
Cableless Measurements Instructions for Use for details.
Removing a Cableless Measurement Device
To remove a cableless measurement device from a monitor and end the assignment:
1 Select the Measurement Selection key.
2 Select the cableless measurement device to be removed.
3 Select the Remove pop-up key.
You can also remove cableless measurement devices in the same way as any other devices using the
Equipment window, see “Using the Equipment Window” on page 96.
To Next Page
Loading...
Need help?
General
