R&S FSV3000 Series - Configuring the R&S FSVA

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1090User Manual 1178.8520.02 ─ 01
//Switch to MultiView tab
DISP:ATAB ON
//Select windows to be stored to file
HCOP:CONT WIND
HCOP:PAGE:WIND:STAT 'Spectrum','1',ON
HCOP:PAGE:WIND:STAT 'Spectrum','2',ON
HCOP:PAGE:WIND:STAT 'IQ Analyzer','1',ON
HCOP:PAGE:WIND:STAT 'IQ Analyzer','2',ON
//Define contents to be printed on each page (logo, timestamp, page count)
DISP:LOGO ON
HCOP:TDST:STAT ON
HCOP:PAGE:COUN:STAT ON
//Define comment to be printed on each page
HCOP:ITEM:WIND:TEXT 'Measurement Test Report'
//Configure page layout (landscape, 1 display per page, margins 2cm on each side)
HCOP:PAGE:ORI1 LAND
HCOP:PAGE:WIND1:COUN 1
HCOP:PAGE:WIND1:SCAL 1
HCOP:PAGE:MARG1:BOTT 20
HCOP:PAGE:MARG1:LEFT 20
HCOP:PAGE:MARG1:RIGH 20
HCOP:PAGE:MARG1:TOP 20
//Configure the use of optimized colors for printout
HCOP:CMAP:DEF2
//Set destination of printout to file for printing device 1
HCOP:DEST1 'MMEM'
//Define file name of printout
MMEM:NAME 'C:\R_S\instr\user\MeasurementTestReport.pdf'
//Set format of printout to PDF.
HCOP:DEV:LANG1 PDF
//Store pdf of printout to file
HCOP:IMM
14.10 Configuring the R&S FSV/A
The remote commands required to set up the R&S FSV/A are described here.
● Configuring the Reference Frequency................................................................ 1091
● Calibration and Checks.......................................................................................1093
● Working with Transducers...................................................................................1097
● Compensating for Frequency Response Using Touchstone files (R&S FSV/A-K544)
............................................................................................................................ 1101
Configuring the R&S
FSV/A