Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1128User Manual 1178.8520.02 ─ 01
14.10.8 Checking the System Configuration
The following commands are required to check the system configuration on the
R&S FSV/A.
Useful commands for obtaining system information described elsewhere:
●
DIAGnostic:SERVice:SINFo? on page 1136
Remote commands exclusive to obtaining system information:
DIAGnostic:INFO:CCOunt?........................................................................................... 1128
DEVice:INFO:HWBand?............................................................................................... 1129
DIAGnostic:SERVice:BIOSinfo?.....................................................................................1129
DIAGnostic:SERVice:HWINfo?...................................................................................... 1130
DIAGnostic:SERVice:VERSinfo?....................................................................................1130
SYSTem:ERRor:CLEar:ALL...........................................................................................1130
SYSTem:DFPRint?.......................................................................................................1131
SYSTem:ERRor:CLEar:REMote.....................................................................................1131
SYSTem:ERRor:EXTended?..........................................................................................1131
SYSTem:ERRor:LIST?..................................................................................................1132
SYSTem:ERRor[:NEXT]?.............................................................................................. 1132
SYSTem:FIRMware:UPDate..........................................................................................1132
SYSTem:FORMat:IDENt............................................................................................... 1133
SYSTem:PRESet:COMPatible....................................................................................... 1133
SYSTem:SECurity[:STATe]............................................................................................ 1133
DIAGnostic:INFO:CCOunt? <Relay>
This command queries how many switching cycles the individual relays have per-
formed since they were installed.
Query parameters:
<Relay> ACDC
Mechanical Attenuation Coupling
ATT5
Mechanical Attenuation 05 DB
ATT10
Mechanical Attenuation 10 DB
ATT20
Mechanical Attenuation 20 DB
ATT40
Mechanical Attenuation 40 DB
CAL
Mechanical Calibration Source
EATT
Electrical Attenuation Bypass
PREamp
Preamplifier Bypass
Configuring the R&S FSV/A
To Next Page
Loading...
