R&S FSV3000 Series - Generator Coupling

General Instrument Setup
R&S
®
FSVA3000/ R&S
®
FSV3000
637User Manual 1178.8520.02 ─ 01
●
All channels
Remote command:
INSTrument:COUPle:USER<uc>:CHANnel:LIST? on page 1144
Specifics for Window ← Add New User Coupling
Selects the windows of the selected channel for which the parameters are coupled.
This setting is only available for Analog Demodulation channels. Individual windows
can only be coupled for frequency markers.
Remote command:
INSTrument:COUPle:USER<uc>:WINDow:LIST? on page 1149
Coupling Element 1 / Coupling Element 2 ← Add New User Coupling
Defines the parameter or marker to be coupled. All available elements in the selected
applications are displayed. If no other active measurement channels have the selected
"Coupling Element 1", "Coupling Element 2" is not available.
Remote command:
INSTrument:COUPle:USER<uc>:ELEMent:LIST? on page 1144
Couple Selected Parameters ← Add New User Coupling
Closes the dialog box and adds the new user-defined coupling definition to the list.
12.10.3 Generator Coupling
You cannot only couple parameters between R&S FSV/A applications, but also
between the R&S FSV/A and a connected signal generator. Coupling parameters is
especially useful when you use the SCPI recorder and need to include generator com-
mands (see "Combined Recording of Spectrum Analyzer and R&S Signal Generator"
on page 691).
Synchronizing Measurement Channel Configuration