Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
740User Manual 1178.8520.02 ─ 01
●
INSTrument:CREate[:NEW] on page 737
Parameters:
<ChannelType> Channel type of the new channel.
For a list of available channel types see INSTrument:LIST?
on page 738.
<ChannelName> String containing the name of the channel.
Example:
INST IQ
INST 'MyIQSpectrum'
Selects the channel named 'MyIQSpectrum' (for example before
executing further commands for that channel).
Manual operation: See "Spectrum" on page 110
See "3G FDD BTS" on page 110
See "3G FDD UE" on page 110
See "5G NR" on page 110
See "Amplifier" on page 110
See "Analog Demodulation" on page 111
See "GSM" on page 111
See "I/Q Analyzer" on page 111
See "LTE" on page 111
See "NB-IoT" on page 111
See "Noise Figure" on page 111
See "Phase Noise" on page 112
See "Pulse Measurements" on page 112
See "Vector Signal Analysis (VSA)" on page 112
See "WLAN" on page 112
See "Selecting an application" on page 114
See "New Channel" on page 115
14.4.2 Performing a Sequence of Measurements
The following commands control the sequencer.
For details on the Sequencer see Chapter 6.4.1, "The Sequencer Concept",
on page 116.
INITiate:SEQuencer:ABORt............................................................................................ 740
INITiate:SEQuencer:IMMediate....................................................................................... 741
INITiate:SEQuencer:MODE.............................................................................................741
SYSTem:SEQuencer......................................................................................................742
INITiate:SEQuencer:ABORt
This command stops the currently active sequence of measurements. The Sequencer
itself is not deactivated, so you can start a new sequence immediately using
INITiate:SEQuencer:IMMediate on page 741.
To deactivate the Sequencer use SYSTem:SEQuencer on page 742.
Usage:
Setting only
Selecting the Operating Mode and Application
To Next Page
Loading...
