Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
738User Manual 1178.8520.02 ─ 01
Example:
INST:CRE:REPL 'IQAnalyzer2',IQ,'IQAnalyzer'
Replaces the channel named "IQAnalyzer2" by a new channel of
type "IQ Analyzer" named "IQAnalyzer".
Usage: Setting only
Manual operation: See "Replace Current Channel" on page 115
INSTrument:DELete <ChannelName>
This command deletes a channel.
Setting parameters:
<ChannelName> String containing the name of the channel you want to delete.
A channel must exist in order to be able delete it.
Usage: Setting only
Manual operation: See "Closing an application" on page 115
INSTrument:LIST?
This command queries all active channels. This is useful in order to obtain the names
of the existing channels, which are required in order to replace or delete the channels.
Return values:
<ChannelType>,
<ChannelName>
For each channel, the command returns the channel type and
channel name (see tables below).
Tip: to change the channel name, use the INSTrument:
REName command.
Example:
INST:LIST?
Result for 3 channels:
'ADEM','Analog Demod','IQ','IQ
Analyzer','IQ','IQ Analyzer2'
Usage: Query only
Manual operation: See "Changing the Channel Name" on page 82
See "Selecting an application" on page 114
Table 14-2: Available channel types and default channel names
Application <ChannelType> Parameter Default Channel Name*)
Spectrum SANALYZER Spectrum
5G NR (R&S FSV3-K144) NR5G 5G NR
3GPP FDD BTS
(R&S FSV3-K72)
BWCD 3G FDD BTS
3GPP FDD UE
(R&S FSV3-K73)
MWCD 3G FDD UE
Note: the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
Selecting the Operating Mode and Application
To Next Page
Loading...
