Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
739User Manual 1178.8520.02 ─ 01
Application <ChannelType> Parameter Default Channel Name*)
Amplifier Measurements
(R&S FSV3-K18)
AMPLifier Amplifier
Analog Demodulation ADEM Analog Demod
GSM (R&S FSV3-K10) GSM GSM
I/Q Analyzer IQ IQ Analyzer
LTE (R&S FSV3-K10x) LTE LTE
NB-IoT (R&S FSV3-K106) NIOT NB-IoT
Noise Figure Measure-
ments
NOISE Noise
Phase Noise (R&S FSV3-
K40)
PNOISE Phase Noise
Pulse (R&S FSV3-K6) PULSE Pulse
Vector Signal Analysis
(VSA, R&S FSV3-K70)
DDEM VSA
WLAN (R&S FSV3-K91) WLAN WLAN
Note: the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel.
Setting parameters:
<ChannelName1> String containing the name of the channel you want to rename.
<ChannelName2> String containing the new channel name.
Note that you cannot assign an existing channel name to a new
channel; this will cause an error.
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
Example:
INST:REN 'IQAnalyzer2','IQAnalyzer3'
Renames the channel with the name 'IQAnalyzer2' to 'IQAna-
lyzer3'.
Usage: Setting only
Manual operation: See "Changing the Channel Name" on page 82
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel with the defined channel type, or selects an
existing channel with the specified name.
Also see
Selecting the Operating Mode and Application
To Next Page
Loading...
