Network and Remote Operation
R&S
®
FSVA3000/ R&S
®
FSV3000
697User Manual 1178.8520.02 ─ 01
13.5.1 General Network Settings
Access: [SETUP] > "Network + Remote" > "Network" tab
The R&S FSV/A can be operated in a local area network (LAN), for example to control
the instrument from a remote PC or use a network printer.
You can define the settings for both the 1 Gbit and the (optional) 10 Gbit connectors
individually.
Risk of network problems
All parameters can be edited here; however, beware that changing the computer name
has major effects in a network.
For details, see Chapter 13.6, "How to Set Up a Network and Remote Control",
on page 710.
Network settings in secure user mode
Be sure to store all network settings before SecureUser Mode is enabled; see Chap-
ter 5.1.7, "Protecting Data Using the Secure User Mode", on page 42.
If the currently stored network settings are not suitable, you must correct them each
time you switch on the R&S FSV/A in secure user mode, as the settings are not stored
permanently in this case.
Network and Remote Control Settings