R&S FSV3000 Series - General Status Register Commands; Reading out the Condition Part

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1153User Manual 1178.8520.02 ─ 01
14.11.1 General Status Register Commands
STATus:PRESet...........................................................................................................1153
STATus:QUEue[:NEXT]?...............................................................................................1153
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined
value. All PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are
detected. All NTRansition parts are set to 0, i.e. a transition from 1 to 0 in a
CONDition bit is not detected. The ENABle part of the STATus:OPERation and
STATus:QUEStionable registers are set to 0, i.e. all events in these registers are not
passed on.
Usage:
Event
STATus:QUEue[:NEXT]?
This command queries the most recent error queue entry and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error
messages defined by SCPI. If the error queue is empty, the error number 0, "No error",
is returned.
This command is identical to the SYSTem:ERRor[:NEXT]? command.
Usage:
Query only
14.11.2 Reading Out the CONDition Part
For more information on the condition part see Chapter 13.1.7.2, "Structure of a SCPI
Status Register", on page 667.
STATus:OPERation:CONDition?
STATus:QUEStionable:CONDition?
STATus:QUEStionable:ACPLimit:CONDition? <ChannelName>
STATus:QUEStionable:EXTended:CONDition? <ChannelName>
STATus:QUEStionable:EXTended:INFO:CONDition? <ChannelName>
STATus:QUEStionable:FREQuency:CONDition? <ChannelName>
STATus:QUEStionable:LIMit<n>:CONDition? <ChannelName>
STATus:QUEStionable:LMARgin<n>:CONDition? <ChannelName>
STATus:QUEStionable:POWer:CONDition? <ChannelName>
STATus:QUEStionable:TEMPerature:CONDition? <ChannelName>
STATus:QUEStionable:TIME:CONDition? <ChannelName>
These commands read out the CONDition section of the status register.
The commands do not delete the contents of the CONDition section.
Suffix:
<n>
.
Window
Using the Status Register