R&S FSV3000 Series - Signal Generator Control Commands

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1134User Manual 1178.8520.02 ─ 01
ON | 1
The R&S FSV/A automatically reboots and starts in secure user
mode. In secure user mode, no data is written to the instru-
ment's internal solid-state drive. Data that the R&S FSV/A nor-
mally stores on the solid-state drive is redirected to SDRAM.
OFF | 0
The R&S FSV/A is set to normal instrument mode. Data is
stored to the internal solid-state drive.
Note: this parameter is for query only. Secure user mode cannot
be deactivated via remote operation.
*RST: 0
Manual operation: See " SecureUser Mode " on page 623
14.10.9
Signal Generator Control Commands
The remote commands required to control connected generators are described here.
CONFigure:GENerator:CONNection:CSTate?................................................................. 1134
CONFigure:GENerator:CONNection[:STATe]...................................................................1134
CONFigure:GENerator:IPConnection:ADDRess.............................................................. 1135
CONFigure:GENerator:CONNection:CSTate?
Queries the state of the connected signal generator.
Return values:
<ConnectionState> UNKNown
no signal generator connected
CONNected
connection established
NCONnected
connection could not be established, possibly due to an incom-
patible instrument or invalid IP address
Example:
CONFigure:GENerator:CONNection:CSTate?
Usage: Query only
Manual operation: See "Test Connection" on page 625
See "Connect/Disconnect" on page 625
CONFigure:GENerator:CONNection[:STATe] <State>
Connects or disconnects the signal generator specified by CONFigure:GENerator:
IPConnection:ADDRess on page 1135. The IP address must be specified before
you use this command.
Parameters:
<State> ON | OFF | 0 | 1
Configuring the R&S FSV/A