R&S FSV3000 Series - 7 Measurements and Results

Measurements and Results
R&S
®
FSVA3000/ R&S
®
FSV3000
120User Manual 1178.8520.02 ─ 01
7 Measurements and Results
Access: "Overview" > "Select Measurement"
Or: [MEAS]
In the Spectrum application, the R&S FSV/A provides a variety of different measure-
ment functions.
●
Basic measurements - measure the spectrum of your signal or watch your signal
in time domain
●
Power measurements - calculate the powers involved in modulated carrier signals
●
Emission measurements - detect unwanted signal emission
●
Statistic measurements - evaluate the spectral distribution of the signal
●
Special measurements - provide characteristic values of the signal
The individual functions are described in detail in the following chapters.
The measurement function determines which settings, functions and evaluation meth-
ods are available in the R&S FSV/A. The various measurement functions are descri-
bed in detail here.
When you select a measurement function, the measurement is started with its default
settings immediately and the corresponding measurement configuration menu is dis-
played. The measurement configuration menu can be displayed at any time by press-
ing the [MEAS CONFIG] key.
The easiest way to configure measurements is using the configuration "Overview" ,
see Chapter 8.1, "Configuration Overview", on page 305.
In addition to the measurement-specific parameters, the general parameters can be
configured as usual, see Chapter 8, "Common Measurement Settings", on page 305.
Many measurement functions provide special result displays or evaluation methods;
however, in most cases the general evaluation methods are also available, see Chap-
ter 9, "Common Analysis and Display Functions", on page 412.
After a preset, and when all other functions are switched off ("All Functions Off" in the
"Select Measurement" dialog) the R&S FSV/A performs a basic frequency sweep.
The remote commands required to retrieve measurement results are described in
Chapter 14.8.2.4, "Retrieving Trace Results", on page 974.
● Auto Measurements..............................................................................................121
● Basic Measurements.............................................................................................122
● Channel Power and Adjacent-Channel Power (ACLR) Measurement..................143
● Carrier-to-Noise Measurements............................................................................195
● Occupied Bandwidth Measurement (OBW).......................................................... 199
● Spectrum Emission Mask (SEM) Measurement................................................... 206
● Spurious Emissions Measurement........................................................................251
● Statistical Measurements (APD, CCDF)............................................................... 264
● Time Domain Power Measurement.......................................................................279