Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1135User Manual 1178.8520.02 ─ 01
OFF | 0
Disconnects the generator.
ON | 1
Connects the generator.
*RST: 0
Example:
CONF:GEN:IPC:ADDR '192.168.114.90'
CONF:GEN:CONN:STAT ON
Manual operation: See "Test Connection" on page 625
See "Connect/Disconnect" on page 625
CONFigure:GENerator:IPConnection:ADDRess
<IPAddress>
The TCPIP address or computer name of the signal generator connected to the
R&S FSV/A via LAN.
The IP address / computer name is maintained after a [PRESET], and is transferred
between applications.
Parameters:
<IPAddress> IP address or computer name
Example:
CONF:GEN:IPC:ADDR '192.168.114.90'
Manual operation: See "IP Address or Computer name of Signal Generator"
on page 624
14.10.10 Using Service Functions
DIAGnostic:SERVice:SFUNction....................................................................................1135
DIAGnostic:SERVice:SFUNction:LASTresult?................................................................. 1136
DIAGnostic:SERVice:SFUNction:RESults:DELete............................................................1136
DIAGnostic:SERVice:SFUNction:RESults:SAVE..............................................................1136
DIAGnostic:SERVice:SINFo?.........................................................................................1136
SYSTem:PASSword[:CENable]......................................................................................1137
SYSTem:PASSword:RESet........................................................................................... 1137
DIAGnostic:SERVice:SFUNction <ServiceFunction>
This command starts a service function.
The service functions are available after you have entered the level 1 or level 2 system
password.
Parameters:
<ServiceFunction> String containing the ID of the service function.
The ID of the service function is made up out of five numbers,
separated by a point.
• function group number
• board number
• function number
Configuring the R&S FSV/A
To Next Page
Loading...
